QuadTech 1865, Инструкция по эксплуатации, Страница: 29 / 87

Operation Page 29 of 87
Section 2 : Operation
2.1
Terms and Conventions
The names of keys in the manual will generally appear in CAPITAL LETTERS.
The MENU key calls up the main menu display and returns to the line previously
selected.
The ">>" symbol on a menu indicates a lower level menu exists.
The select keys generally function as UP, DOWN, LEFT and RIGHT arrow and allow
you to move through a menu or field of choices to make the desired selection or turn a
function ON or OFF.
The ENTER key switches the unit to entry mode and when pressed again initiates the
entry or choice selected on the current screen.
The CNCL key will return the system to main menu display with no changes made.
(From a numeric data field CNCL must be hit twice).
2.2 Startup
Check to make sure the line voltage indicator on the rear panel AC inlet module agrees
with the AC power source available, if not refer to paragraph 1.5.3.
Connect the instrument power cord to the source of proper voltage. The instrument is
to be used only with three wire grounded outlets.
WARNING
A flashing CAUTION HIGH VOLTAGE light and/or DANGER on the display indicates
a defective unit with dangerously high voltages possible at the input terminals. Power
the unit down and do not use.
IMPORTANT
The interlock connector (included with the unit) needs to be installed on the rear panel
I/O Port connector if the interlock function is not being used.
When the 3.5" Floppy Drive Option is present ALWAYS MAKE SURE NO DISKS
ARE INSTALLED WHEN THE UNIT IS POWERED UP, otherwise information stored
on the disks could be lost.
Switching [POWER] OFF and ON quickly may result in error messages. Power should
be off for at least 10 seconds to assure proper power-up.