QuadTech 1865, Инструкция по эксплуатации, Страница: 52 / 87

Page 52 of 87 Operation
Setup
I/O
>>
Y
N
SAVE AS XXXXX?
Utilities
Figure 2-23: Save/Overwriting Setup
To make the current set of test conditions the default (at power up) one needs to select
[DEFAULT] in the Save Setup menu and overwrite the conditions currently stored. To
prevent overwriting the default setup by mistake an additional level of safety exists
where the operator is required to respond with Yes or No, similar to Figure 2-23.
Selecting [del] will delete a set of test conditions and requires a Yes or No response.
When there are more setups than can fit on the display the page down key is active. If
there is less than a whole page below, the display wraps around to the previous display.
Continuing to page down will eventually return to the first display of setups. The page
down key is only shown when there are more setups than what is visible.
There are two ways to make the current set of test conditions overwrite an existing setup,
one is to select that setup in the menu and answer Yes to overwrite and the other way is
to enter the same name under New and answer Yes to overwrite.
Setup
Save
I/O Utilities
NEW
Cable-2
Cap-1
Cap-2
Rstr-1
Rstr-2
1865-100
1865-102
1865-103
1865-104
d
e
l
Figure 2-24: Saving Setups on Floppy