QuadTech 1865, Инструкция по эксплуатации, Страница: 23 / 87

Introduction Page 23 of 87
Table 1-1: Front Panel Controls and Indicators (Continued)
Reference
Number
Figure 1-1 Name Type Function
5 MENU Green Push Button Press to enter menu display mode or press
to exit sub menu & return to main menu.
6 CNCL Gray Push Button To exit menu mode with no parameter
changes made or to exit current field
7 ENTER Gray Push Button To switch user to entry mode or to accept
menu entry as entered.
8 START Green Push Button To initiate the measurement
9 POWER Black Toggle
Switch
To apply power to the instrument:
1 = ON, 0 = OFF
10 OPTION 3 ½ “ Floppy Drive To store test setup conditions and
measurement results. High Density (HD:
1.44M) or Low Density (LD: 720k)
compatible floppy drive. Floppies should
be double sided and formatted for DOS
compatibility.
11 STOP Red Push Button To stop the measurement (terminate high
voltage at the output terminals)
12 TEST Indicate P/F Measurement Result based on
preset limit
12a FAIL Red LED When lit in Resistance Mode , the measured
value is below the set minimum value
(resistance limit).
When lit in
Current Mode , the measured
value is above the set maximum value
(current limit).
12b PASS Green LED When lit, in Resistance Mode , the measured
value is above the set minimum value
(resistance limit).
When lit in
Current Mode , the measured
value is below the set maximum value
(current limit).
13 Caution High Voltage Red LED When lit, indicates presence of High
Voltage at the output terminals.