Qlogic QLA2 Series, Руководство пользователя

Страница: 82 / 348

3–Interactive Commands
HBA Parameters Menu
3-30 SN0054614-00 K
Enable HBA Port BIOS
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable HBA Port BIOS
This option allows you to enable or disable the BIOS boot setting. When this
setting is disabled, the ROM BIOS on the adapter is disabled. If you are booting
from a FC hard disk attached to the adapter, you must enable this setting. The
default is disabled.
Enable HBA Hard Loop ID
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable HBA Hard Loop ID
This choice gives you the option to enable or disable the Hard Loop ID. Type the
number you want, and then press ENTER.
Enable Fibre Channel Tape Support
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable Fibre Channel Tape Support
This choice gives you the option to enable or disable Fibre-Channel Tape support.
Type the number you want, and then press ENTER.
Operation Mode
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Operation Mode
This option shows the Operation Mode Menu . From it you can select:
„ Interrupt for every I/O Completion
„ Interrupt when Interrupt Delay Timer expires
„ Interrupt when Interrupt Delay Timer expires or no active I/O
Type the number for the Operation Mode you want, and then press ENTER.
Interrupt Delay Timer
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Interrupt Delay Timer
This choice gives you the option to set the Interrupt Delay timer to 0 to 255
seconds.
You cannot set the Interrupt Delay timer when the Operation Mode (blue) is set to
Interrupt for Every I/O Completion.
Execution Throttle
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Execution throttle _
This choice gives you the option to set the Execution Throttle to a value from 1 to
65535. This value specifies the delay in seconds between the execution of each
line of code.