Qlogic QLA2 Series, Руководство пользователя

Страница: 198 / 348

4–Non-Interactive Commands
Command Summary
4-24 SN0054614-00 K
„ 12 (Windows)
„ 25 (Solaris)
„ 2 (Linux and Macintosh)
The default test increment is 1. The test increment cannot be larger than the
number of tests run (see
“TestCount (TC)” on page 4-23 ).
OnError (OE)
For the loopback test, OnError is either:
OE < param value >
OnError <param value>
This parameter determines how errors are handled if they occur during any given
pass.
Table 4-8 lists the valid values.
LoopbackType (LT)
For the loopback test only, the loopback type parameter specifies the type of
loopback tests that you can select from, as shown in
Table 4-9 .
Be sure to select the appropriate adapter connector for testing. For internal
loopback, a loopback connector must be plugged in the adapter connector.
Run a Loopback Test
The loopback test sends and receives messages, through a loopback or through
an echo command, to the switch.
Table 4-8. OnError Values
Value Description
0 The error is ignored. This is the default value.
1 The test stops on error.
2 On error, the data pattern and test repeat until the error is cleared.
Table 4-9. LoopbackType Values
Value Description
0 10 bit internal loopback test.
1 1 bit serial loopback test.
2 External loopback test.