15
2
2.1
Getting Started
Quick Start Guide
Monitor StationV2
Owner’sManual
2.1.8
Connect the CueOutputs “Cue Outputs”
连接
In addition to the four individual amplified headphone jacks on its front
panel, the Monitor Station V2 provides rear-panel Cue L/R Line Outputs
that you can connect to a separate headphone amplifier. Their audio is
selected using the front-panel Cue Source buttons, as described
in Section
4.1.2.
You can set their level using the front-panel Cue Output knob, as
explained
in Section 4.1.2.
除了前面板上的四个独立的放大耳机接口外，
Monitor Station V2
还提
供了后面板的
Cue L/R Line
输出，可以连接到独立的耳机放大器上。
如
第
4.1.2
节所述 ，
它们的音频是通过前面板上的
”Cue Source”
按钮
来选择的。你可以使用前面板的
”Cue Source”
旋钮来设置它们的音
量，如
第
4.1.2
节所述
。
Here’s how to calibrate a headphone amplifier.
以下是如何校准耳机放大器的方法。
1. Zero the Main Level and Cue Output knobs by turning them
fully counterclockwise.
将
”Main Level”
和
”Cue Output”
旋钮逆时针完全旋转，使其
归零。
2. Connecttheinputs of the headphone amplifiertotheMonitorStationV2’sCue
L/R Line Outputs.
将耳机放大器的输入连接到
MonitorStation V2
的
Cue L/R
线路输出。
3. Calibrate the device’s audio levels according to its user manual or visit its
manufacturer’s Web site for information about the recommended calibration
process.
根据设备的用户手册校准它的音频音量，或访问其制造商的网站，了解有
关校准过程的推荐信息。
Note
:
If the headphone amplifier doesn’t have a recommended calibration
process, increase the Monitor Station V2’s Cue Output knob to Unity Gain
by turning it fully clockwise and then adjust the amplifier’s input level as
necessary.
注意：如果耳机放大器没有推荐的校准过程，将
Monitor Station V2
的
”Cue Output”
旋钮完全顺时针旋转到统一增益，然后根据需要调整
放大器的输入音量。
