12
2
2.1
Getting Started
Quick Start Guide
Monitor StationV2
Owner’sManual
2. Zero the Monitor Station V2’s front-panel Main Output Level knob, the Cue
Output knob, individual headphone Level knobs, and the rear-panel Speaker
A Output trim by turning them fully counterclockwise.
将
Monitor Station V2
的前面板
”Main Output Level”
旋钮、
”Cue Output”
旋
钮、各个耳机电平旋钮和后面板的扬声器
A
输出，逆时针微调旋转到底。
3. Position your SPL-metering device as described above.
如上所述，将你的声压级测量设备放置好。
4. On the Monitor Station V2, press the ST1 Main Source and Speaker A Speaker
Select buttons so they light. Make sure no other sources or speakers are
turned on.
在
Monitor Station V2
上，按住
”ST1 Main Source”
主音源和
”Speaker A
Speaker Select”
按钮，使它们亮起来。确保没有其他声源或扬声器被打
开。
5. In your DAW, or on your noise generator, pan the pink noise all the way to the left,
since we’ll start by calibrating the left speaker.
在你的
DAW
中，或在你的噪声发生器上，将粉红噪声一直移到左边，因为
要从校准左边的扬声器开始。
6. Make sure your pink-noise source isn’t going through any signal processing so it’s
as clean as possible.
确保你的粉色噪声源没有经过任何信号处理，所以尽可能的会干净。
7. Begin playing pink noise; you shouldn’t hear it, since you turned everything down
in step 1. If you do hear it, repeat step 1.
开始播放粉红噪音；你不应该听到它，因为你在步骤
1
中，把所有都调低
了。如果你确实听到了，重复第
1
步。
8. Set the Monitor Station V2’s front-panel Main Output Level knob to Unity Gain by
turning it fully clockwise.
将
Monitor Station V2
的前面板
”Main Output Level”
旋钮顺时针旋转到统一增
益。
9. Set the Monitor Station V2’s rear-panel Speaker A Output trim to fully clockwise.
You may begin hearing the test tone playing through your speakers.
将
Monitor Station V2
的后面板
”Speaker A Output”
调节器，设置为顺时针全
开。通过扬声器，开始你可以听到播放的测试音。
monitors
SPL
meter
