Tel: (888) 545-1254 • Fax: (415) 358-4602 • Email: [email protected]
www.PrecisionRatedOptics.com
34
6.1 Connectors
The TP-P6 comes standard with FC and PC optical port connectors. It can also accommodate SC and ST
connectors, which are available from Precision Rated Optics.
6.2 Cleaning and Connecting to Optical Fiber
To ensure measurement accuracy, always clean and connect the fiber properly before testing.
Tools are not required to connect fiber to the OTDR.
●
Please refer to “Maintenance and Calibration” for optical port and connector cleaning.
●
After cleaning the connectors, verify that the correct connectors are being used.
●
Connect the fiber to be tested to the OTDR port.
Note:
Improperly connected fiber can cause many problems, including highly innaccurate test results, caused by
light loss and/or scattering.
Warning!!
To ensure your personal safety, please refer to the Safety Instructions of this manual before testing.
Caution
●
When testing with the OTDR, unless connected to specific optical port, please make sure there is no
operational laser in the fiber under test. Failure to do so may cause incorrect test results, or even
permanent damage to the equipment.
●
Please do not screw connectors too tightly, or damage may occur to the fiber and/or optical ports.
6 Preparing to use the OTDR
Содержание TP-P6
Страница 1: ...TP P6 Manual Multifunctional Test Platform...