PERCo CT/L-14, Руководство по сборке и эксплуатации

Страница: 10 / 58

CT/L-14 Controller
9
Table 2. Jumper installation on XP1 connector
N Jumper position on XP1 Method of specifying IP address
1 User mode
2 “IP MODE”
3 “IP DEFAULT”
5.4 Input signals parameters
5.4.1
IN1
–
IN6
inputs
The controller provides status control of four inputs controlled by “dry contact” or “open collector”
(
OC
):
IN1 – IN6
. Connection to the outputs is performed via
XT1
terminal block of the controller
lower board (Fig. 1 and 3).
Note:
To create a high-level signal on all input contacts
IN1 – IN6,
2 kOhm resistors connected to
+3.3V power line are used.
Inputs can be used for following connections:
• IN1:
o door sensor 1 (reed switch),
o PASS output of a turnstile 1,
o intrusion detectors of a vehicle checkpoint 1;
•
IN2:
o door sensor 2 (reed switch),
o PASS output of a turnstile 1,
o optional equipment (IN #2);
•
IN3:
o door sensor 3 (reed switch),
o PASS output of a turnstile 2,
o intrusion detectors of a vehicle checkpoint 2,
o optional equipment (IN #3);
• IN4:
o door sensor 4 (reed switch),
o PASS output of a turnstile 2,
o optional equipment (IN #4);
•
IN5
,
IN6:
o optional equipment (IN #5, IN #6)
.
Signals activation depends on description of their default status in
Normal status of contact
parameter in PERCo-Web software:
• If the input is described as
Open
, it is activated by a turn-on of low-level signal relative to
GND
contact. In such case a normally open relay contact or an open collector output circuit
may be a control element.
• If input is described as Closed , it is activated by a turn-off of low-level signal relative to
GND
contact. In such case a normally closed relay contact or an open collector output
circuit may be a control element.
Note:
• IN1 input is configured as “Closed” by default.
• If according to the configuration of the controller IN2, IN3 or IN4 input is used to connect
the door sensor / intrusion detectors / PASS, by default it is configured as
Closed
with
the possibility of further changes.