75
31. Change “SFTP periodic image transmission error” to “FTP/SFTP
periodic image transmission error” in “Save trigger” of SD memory card.
<SD memory card supported models only>
(Operating Instructions – Configure the basic settings of the camera [Basic]
–
Configure the settings relating to the SD memory card [SD memory card])
By adding the FTP function to the SFTP function, Change “SFTP periodic image transmission error” to
“FTP/SFTP periodic image transmission error” in “Save trigger” of recording stream.
Recording stream
[Save trigger] button
Select a trigger to save images on the SD memory card from the following.
•
FTP/SFTP periodic image transmission error:
Saves images when images have failed to transmit to
the FTP/SFTP server by the FTP/SFTP periodic image transmission function. Available only for the
“JPEG(1)” or “JPEG(2)” images.
•
Alarm input:
Saves images at an alarm occurrence.
•
Manual:
Saves images manually.
•
Schedule:
Saves images in accordance with the settings for “Schedule”. Available only for the
“Stream(1)”, “Stream(2)”, “Stream(3)”, or “Stream(4)” images.
•
Default:
Manual
If you have selected “Alarm input” in the [Save trigger], you can select the alarm type from the following:
Terminal1-3 <Terminal input/output supported models only>
•
Terminal 1:
Save the image when an alarm occurs in Terminal 1.
•
Terminal 2:
Save the image when an alarm occurs in Terminal 2.
•
Terminal 3:
Save the image when an alarm occurs in Terminal 3.
•
VMD:
Save the image when motion detection occurs.
•
SCD:
Save the image when SCD occurs.
•
Command alarm:
Save the image when a command alarm is entered.
The following functions are unique for PTZ camera
＜
PTZ S
only
＞
•
Auto track:
Save the image when an auto track occurs.
Note
• When “Stream(1)”, “Stream(2)”, “Stream(3)”, or “Stream(4)” is selected for “Recording format”,
“FTP/SFTP periodic image transmission error” is unavailable.
• To enable alarms to occur, alarm settings must be configured in advance on the [Alarm] tab.
• When “JPEG(1)” or “JPEG(2)” is selected for “Recording format”, “Schedule” is unavailable.
• When connected with our network disk recorder, “Save trigger” may be displayed in a gray-out state
as “Network failure”. To change the setting of “Save trigger” after disconnecting the recorder, set “Not
use” for “SD memory card” once and then set “Use” again.
• Alarm recording is not available for streams that are being distributed in a state where
“
Advanced(Fixed GOP 60s w/1s key-frame)” is selected for “GOP control”.
• No image will be recorded at the time of an audio detection alarm occurrence.
