22
Preparation: P2 Cards
P2 Cards
Note:
“FORMAT ERROR!” or “NOT SUPPORTED!” may appear if a microP2 memory card is inserted slowly. Should this happen, reinsert it.
The unit supports separately sold P2 memory cards and microP2 memory cards of 4 GB to 64 GB. (As of October 2013)
Note:
• When AVC-Intra100 of 1080/60P and 1080/50P is selected, recording to the following P2 cards is not possible.
- H, R, A, and E series P2 memory cards.
• AJ-P2C002SG (2 GB) cards cannot be used.
• The unit may need to be updated depending on the type of P2 card.
• For the latest information not available in the Operating Instructions, visit the website. (
➝
“Website URL” page 8)
P2 Card Access Lamp and P2 Card Status
P2 Card Access Lamp
P2 Card Status
Lights green
Recording possible
Both writing and reading are possible.
Lights orange
Recording target
Writing and reading are enabled and currently recording target.
Flashing orange
Card being accessed
Writing or reading is in progress.
Fast flashing orange
Card being recognized
The P2 card is being recognized.
Slow flashing green
Card full
There is no available space on the P2 card. Only reading is possible.
Write protected
The write-protect switch on the P2 card is set to Protect. Only reading is pos-
sible.
Card not supported for re-
cording
Recording is not possible with the currently set recording format because an
SD memory card or other unsupported card is inserted. To record, change
the recording format or use a P2 card.
Slot not target for record-
ing
A card has been inserted in a different slot from that of "REC MEDIA" (P2/
microP2) (
➝
page 87) of the "REC/PB SETUP" menu item.
Off
Card not supported
The card cannot be used with the unit. Replace the card.
Format invalid
The P2 card is not formatted properly. Reformat it.
No card
A P2 card is not inserted. Waiting for the card to be recognized.
Card cannot be authenti-
cated
A micorP2 memory card for which authentication is not possible. Refer to
“Manual and Automatic CPS Authentication” (
➝
page 46) and then perform
authentication.
No USB access
The P2 card is not accessible using USB device mode.
P2 Card Recording Times
P2 cards supported by the unit
