User’s Manual
50
Move the cursor over the date and time and press the (Play/Pause) button. You can use the Left and
Right arrow buttons to highlight the year, month, day, hours, minutes and seconds. Use the Up and Down
arrow buttons to change to the date and time you want to search for video.
Once you have set the date and time you want, press the button. Then highlight
Go
and press the
button. The selected date and time will display. (If no video was recorded during the selected time, a
message appears alerting you that no image was recorded at that time.) The button and arrow buttons
can now be used to review the surrounding video.
Export
Selecting (Export) in the Search menu allows you to clip a video segment and save it. It is the same as
pressing the
CLIP COPY
button on the front panel. See the following
Clip Copy
section for details.
A–B Clip-Copy:
Selecting
A–B Clip-Copy
will set the starting point of the video to be clip copied, and
the icon displays at the bottom-left corner of the screen. Selecting
A–B Clip-Copy
again will set the
ending point of the video to be clip copied and displays the
Clip-Copy
screen.
Clip-Copy
: Select
Clip-Copy
, and the
Clip-Copy
screen appears to allow clip copy setup.
Camera Menu
Selecting (Camera Menu) in the Search menu displays the following Camera Menu.
NOTE: The video signal has a time difference of 1/60 second (1/50 second for PAL) between odd
and even fields because it is composed of 60 interlaced fields per second (50 fields for PAL). When
recording video with Very High (D1) resolution, video is made up of frame units combining two fields –
one odd field and one even field. This can cause horizontal scan lines or flashes in areas with motion
because of the time difference between the two fields. Turning on the de-interlace filter provides
clearer video by eliminating these horizontal scan lines and flashes.
NOTE: The
Camera Menu
also can be displayed by clicking the right mouse button on the screen
while in the search mode.
Alarm Reset
Selecting (Alarm Reset) in the Search menu resets the DVR’s outputs including the internal buzzer during
an alarm. It is the same as pressing the
ALARM
button on the front panel.
Panic
Selecting (Panic) in the Search menu starts panic recording of all cameras, and selecting again stops
panic recording. It is the same as pressing the
PANIC
button on the front panel.
Data Source
Selecting (Data Source) in the Search menu allows you to select the data source to be searched. Selecting
Record
searches recorded data on primary storage installed in the DVR, and selecting
Other
searches
recorded data on storage used for another DVR then installed in this DVR.
Zoom:
Selecting
Zoom
and choosing the camera number zooms the current playback
image of the selected camera on the screen. It is the same as pressing the
ZOOM
button
on the front panel. Selecting
Zoom
again exits the Zoom mode.
Audio:
Selecting
Audio
toggles audio playback On and Off. Recorded audio will
be played when the DVR displays a camera with recorded audio in full screen mode.
Enable De-Interlace:
Selecting
Enable De-Interlace
turns the de-interlace filters on.
