Keratron™ Installation and operating manual
OPTIKON 2000
Cod. 161501EN
9-9
2014-04-23
Rev.0
9.5 CONFIGURATION OF THE CONNECTION TO THE EXTERNAL
PC USING A LOCAL NETWORK
The connection of Keratron
™
by means of a
router
, to an existing (wireless or wired)
LAN, should be performed under the supervision of the network administrator. The
following sections illustrate the preliminary operations to set the TCP/IP configuration
of Keratron
™
for networks that use a dynamic protocol for the configuration of
addresses (DHCP) and a static one.
9.5.1
AUTOMATIC CONFIGURATION OF THE ADDRESS (DHCP)
If
Keratron™ is connected to a network where addresses are changed
dynamically, it is possible to follow the procedure shown in Figure 9-9.
Figure 9-9: Selection of the DHCP mode
If Keratr
on™ has a
wireless
connection, it is necessary to enter the network card you
wish to use in the LAN card field. If DHCP has been configured for the
Remote Host
Computer
, it is not possible to identify it using a static IP address. In
this case, the
assignment can be done using the name that displays on the LAN network. By
selecting the box shown in Figure 9-10, it is possible to display a virtual keyboard
and enter the name on
touchscreen.
