Keratron™ Installation and operating manual
OPTIKON 2000
Cod. 161501EN
9-8
2014-04-23
Rev.0
NOTE:
To configure the network it is necessary to be in possession of system administrator
privileges (Administrator).
9.4.3
CONFIGURATION OF KERATRON
™
If you select Settings in the initial screen and the Network folder, it is possible to
display the Ethernet connection shown in Figure 9-8.
Figure 9-8: Network configuration window for Keratron
™
The
Remote Host IP
(1) is the PC IP address used to exchange data with
Keratron
™
Scout. If a direct Ethernet connection is used, this address is the one set
on the PC, as specified in sections §9.4.1 and §9.4.2. If it is necessary to change the
PC IP address, it will be necessary to enter the new address also in field
Remote
Host IP
on the
Keratron™.
Network administrators can change the TCP/IP configuration of
Keratron™ by
selecting button
“
Local TCP/IP Settings
” (2 in Figure 9-8).
The functions available in this configuration are illustrated in section §9.5, that
explains how to configure
Keratron™ on a LAN network.
By pressing
“
Factory Default
” (3 in Figure 9-8) it is possible to reset the original and
factory preset TCP/IP configuration.
