Keratron™ Installation and operating manual
OPTIKON 2000
Cod. 161501EN
7-8
2014-04-23
Rev.0
Option [Service] in Figure 7-12 is intended to be used under the supervision of
Optikon 2000 S.p.A. personnel or personnel authorized by them for updates or
internal tests of the unit’s functioning.
In any case, the option is protected with a password to prevent accidental access.
Any attempt to access this section violates the terms of the warranty.
The
Network
(Figure 7-13) folder contains the configuration for the direct Ethernet
connection with an external PC (
Remote host IP
;
Remote port
), by means of a
“crossed” cable or by means of a local network (
Remote Computer Name
;
Local
TCP/IP Settings
) ).
For further information on how to configure the external PC (in the first case) or
change the local settings (in the second case), refer to sections § §9.4 or §9.5.
Figure 7-13: Configuration for the connection to a PC by means of Ethernet
NOTE:
If a direct connection is used and the parameters are changed in Figure 7-13, it will
also be necessary to set the same configuration on the external PC. If a local
network connection is used, it will be necessary to ask the network administrator to
appropriately change the TCP/IP local settings.
Unless this operation is performed by personnel with specific training on PCs or on
LAN configuration, it is advisable not to modify the values shown in this page.
If case of doubt on the changes applied, it is advisable to reset the factory values by
pressing [Factory default].
In section
Localization
(Figure 7-14) you can set the language of the
Keratron™
software by choosing one of the available languages.
