4-18
Example of an n. + 4 Digits Parameter Setting
PR02W
operation
Front panel
key operation
Display example
Explanation
(Present setting)
(less than
1 s)
Digit No. 3 Digit No. 0
Set the digit No. to be operated using the Left Key (front
panel: DATA Key for less than 1 s) or Right Key. You
cannot use only the Up and Down Keys.
Saving the Changed Setting to Memory
•
The following operation is not necessary if you are only checking the settings.
PR02W
operation
Front panel
key operation
Display example
Explanation
(1 s min.)
Press the DATA Key (front panel: DATA Key for 1 s min.)
to save the data to memory (the setting display will flash
for approximately 1 s).
(After approx. 1 s)
After the display has finished flashing, it will return to
normal.
D
Return to Parameter Number Display
PR02W
operation
Front panel
key operation
Display example
Explanation
(1 s min.)
Press the DATA Key (front panel: DATA Key for 1 s min.)
to return to the parameter No. display.
4-4-2 Parameter Tables
•
Some parameters are enabled by turning OFF the Unit, then turning it ON again. (See the tables be-
low.) When changing these parameters, turn OFF the power (check that the power lamp is not lit), then
turn ON the power again.
•
The specific digit number of a parameter for which each digit number must be set separately is dis-
played in the table with “.0” added to the digit number. For example, Pn001.0 (i.e., digit No. 0 of param-
eter No. Pn001).
•
The default setting for parameters set using 5 digits are displayed in the table with the leftmost digits
not shown if they are 0 (e.g., if the default setting is 00080, 80 is entered in the table).
•
Do not set parameters or digit numbers shown as “Not used.”
Operation
Chapter 4
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]