Omega DP41-B Series, Руководство пользователя

Страница: 77 / 132

67
Multi-Point Scale and Offset Menu Configuration
18
18
ON.L INE IF " ON.L INE " and " NUM.PNt " = 01 are YOUR CHOICE:
(On-Line Calibration with 2 points)
Press ‘ RESET/ENTER ’ 6) Display stops flashing " ON.L INE " On-line Calibration or Scaling.
Press ‘ RESET/ENTER ’ 7) Display shows " INPUt 0 " .
Press ‘ RESET/ENTER ’ 8) Display shows the actual live-input signal being received and equal to
approximately the minimum input signal or 0% of known load range.
Press ‘ RESET/ENTER ’ 9) Display shows " StOREd " momentarily and advances to " REAd 0 " .
Press ‘ RESET/ENTER ’ 10) Display shows last stored value of " REAd 0 " with 1st digit flashing.
Press ‘
䊱
/MAX ’ & ‘
䊳
/MIN ’ 11) To enter the value of " REAd 0 " .
Press ‘ RESET/ENTER ’ This value corresponds to " INPUt 0 " in terms of some meaningful
engineering units. To show " INPUt 0 " as minimum or 0% as enter
" REAd 0 " value = 000000 (Example)
Press ‘ RESET/ENTER ’ 12) Display shows " INPUt 1 " .
Press ‘ RESET/ENTER ’ 13) Display shows the 2nd higher live-input signal being connected for
your preference as equal to approximately 100% of the transducer range
or the max. Input signal.
Press ‘ RESET/ENTER ’ 14) Display shows " StOREd " momentarily and advances to " REAd 1 " .
Press ‘ RESET/ENTER ’ 15) Display shows last stored value of " REAd 1 " with 1st digit flashing.
Press ‘
䊱
/MAX ’ & ‘
䊳
/MIN ’ 16) To enter the value of " REAd 1 " . This value corresponds to " INPUt 1 "
in term of some meaningful engineering units. To show " INPUt 1 " as
maximum or 100% as enter " REAd 1 " value = 000100 (example).
Press ‘ RESET/ENTER ’ 17) Display shows " StOREd " momentarily and advances to " OUt.CNt "
Output configuration menu.
MANUAL IF " MANUAL " and " NUM.PNt " = 01 are YOUR CHOICE
(Scaling without Known Loads or based on specifications)
To scale " MANUAL " , calculate inputs based on transducer specifications and manually enter them via
on the front panel push buttons. The following example assumes load cells with this specification:
Maximum Load:....................................................................100.0 lb
Output ................................................................................3.0 mV/V
Sensor Excitation ......................................................................10 V
Maximum Sensor Output = 3.0(mV/V) x 10(V) = 30mV