DMTA-10040-01EN, Rev. E, February 2018
Control Functions
79
•
Only the gain, angle, and frequency are controlled by knobless entry.
•
The following steps assume that the MAIN FILTER menu key (
) has been
pressed.
To use knobless entry
1.
Enable the knobless function in the
SYSTEM SETUP
screen (see “Enabling
Knobless Entry for Harsh Environments” on page 68).
2.
Press the A (
FREQ,
or frequency), B (
ANGLE
), or C (
GAIN
) function key.
Consecutive presses of the C (
GAIN
) function key allow you to toggle through the
various gain control options in the following order:
H/V GAIN
(combined horizontal
and vertical gain),
H
‑
GAIN
(horizontal gain), followed by
V
‑
GAIN
(vertical gain).
Subsequent presses of the C key will continue the toggling cycle.
3.
Press the D (
UP
) function key to increase the setting.
OR
Press the E (
DOWN
) function key to decrease the setting.
4.2.8
Ambidextrous Controls
It is possible to change the location of control functions on the instrument screen, to
adapt to both left-handed and right-handed operation.
To enable ambidextrous controls
1.
Press the ADV SETUP menu key (
) twice, and then press the B key to access
the
SYSTEM SETUP
screen (see Figure 4-8 on page 80).
NOTE
NOTE
Содержание nortec 600
