Okolab H301-T-UNIT-BL-PLUS, Руководство пользователя, Страница: 16 / 45

16
The RED indicator means that there could be a problem with the unit. If after 20-30 minutes
the Red light does not turn to Green, turn the system off, wait 5 minutes and turn it back on.
If the problem persists contact Okolab at http://www.oko-lab.com
6.1.2 Changing Set Points
To change a set point, simply touch the corresponding tab. A new page will open where you can press +/ –
to adjust the temperature to the desired value from 3°C above ambient to 60°C. Press “Set” to save the
new set point or “Cancel” to undo.
Figure 8. How to change the Temperature set point
6.2.1 Temperature
Temperature Settings are adjusted by following the two steps below (look at the touching finger)
Figure 9. Temperature settings
6.2.1.1 Chamber/Adapter
Figure 10. Here you have to set the model of incubating chamber (it depends on your XY stage/piezo) that
you have purchased and the type of sample adapter being inserted into it. Depending on these selections,
the thermal controller will automatically change settings. To switch configuration press on the Chamber or
on the Adapter icon (see Figure 10), then scroll among different chambers/adapters using the arrows on the
left and right sides of the screen. If you choose to change the chamber, when the chamber you are about
to use appears on the screen press “Next”. Repeat this sequence to find and select the sample adapter (see
Figure 11) and press “ Ok ” (see Figure 12). The unit will save these settings.
1
2