Oce CS6410, Основное руководство по эксплуатации

Страница: 49 / 98

49
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
1
Install a paper tube to the scroller.
(1)
(2)
(3)
Run the paper tube through the two paper tube
flanges so that each paper tube flange's fixing screw
side would face outward.
Confirm that the rubber spacer A is facing the
correct orientation, and crown the rubber spacer
A on the flange spacer.
Fix the rubber spacer C to the scroller.
Paper tube flange
When the paper tube width is the same as the media width
When the paper tube width is the same as the media
width
Remove the two screws and move the roll spacer to the center of
the media. There are three screwing positions.
Paper tube
Roll spacer
Scroller
Do not move this roll
spacer.
Insert the scroller into the paper
tube, determine the distance
between the media edge and
the flange.
Paper setting
gauge
Flange
Attach the paper setting gauge’s flange side to
the flange’s spoke side.
Rotate the handle clockwise as far as it will
go, and then secure the scroller at the
point.
Handle
(1) The flange spacer has teeth. Push it as far as it will
go.
(2) Match the flange stopper with the claw of the
flange spacer
(3) Tighten the knob to secure the flange spacer and
the flange stopper.
Knob
Paper tube
Flange stopper
Flange spacer
Rubber spacer C