Oce CS6410, Основное руководство по эксплуатации

Страница: 33 / 98

33
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
8
Blip
♪
Platen
Feed media for 1m more after the blip.
In this state, smooth out the media toward the both
sides on the platen to make the media center tense.
Point to be checked
- If the media is set with a distortion or wrinkles,
this may cause a media jam or skew.
9
Feed back the media.
Feed back the media while pressing the center of the
media gently at the supply side.
Confi rm that the front media edge precedes the
closed front cover by approx. 30 cm.
30cm
Important!
- Step 9 is important to set the media properly.
10
Takeup side
Set the pressure to “Normal” by rotating the
pressure control knob counterclockwise.
Point to be checked again
- Check whether the media on the platen has no
fl oat or wrinkles.