Oce CS6410, Основное руководство по эксплуатации

Страница: 39 / 98

39
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
6
Paper
tube
Tape
Install the printed media to the paper tube.
(1) Check the take-up direction, remove the slack of the
media, and then make sure that the media is not
deviated on the supply side and the takeup side.
(2) With tape hold the media straight at the center, and
then at the rest six positions in the direction from
the media center to the media edge.
Inner take-up:
Media is taken up with its
print surface coming inside.
Outer take-up:
Media is taken up with its print
surface coming outside.
Points to be noted on winding media
- If the media is not installed straight to the paper tube, a skew of media may occur.
- When the take-up direction is set as Inner take-up, the taken-up
media's diameter increases and the media
cannot backfeed after printing. Select [FWD ONLY] beforehand in MEDIA BACK MODE of MEDIA REG MENU.
(When the media backfeeds in [BACK&FWD] mode, the motor idles and may cause a trouble.)
7
Take-up direction switch
OFF
u
Outer take-up
- OFF
v
Inner take-up
Set the take-up direction switch according to
the take-up direction.
8
By pressing the key feed the media, and
wind one full turn of the media on the paper
tube.
F E E D I N G M E D I A
CAUTION
- If the tension bar is attached without winding the
media by one turn, the tape will peel off .