Oce CS6410, Основное руководство по эксплуатации

Страница: 35 / 98

35
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
17
Adjust the tension bar length.
To print in TENSION winding mode: Conform the tension bar length with the media width.
The table below lists the tension bar combination and the tension bar’s total length. Referring to the list, apply
the tension bar length nearest to the media width.
To print without winding: The table below lists the tension bar combination and the tension bar’s total length.
Referring to the list, apply the tension bar length nearest to the media width.
Tension bar length Examples of tension bar combinations
Tension bar combination Tension barʼs total length
S 16 inches (41 cm)
M 24 inches (61 cm)
ML -
S, S 32 inches (82 cm)
M, S 40 inches (102 cm)
ML, S -
L 48 inches (123 cm)
M, S, S 56 inches (143 cm)
ML, S, S -
L, S 64 inches (164 cm)
L, M 72 inches (184 cm)
L, ML -
L, S, S 80 inches (205 cm)
L, M, S 88 inches (225 cm)
L, M, S, S 104 inches (266 cm)
When the tension bar is almost same as the media width, or is slightly longer than the media width, set the
tension bar with screws to the tension bar.
Media
Tension bar
fl ange with
screw
Tension
bar fl ange
with screw
Tension bar
When the tension bar is clearly longer than the media width, set the tension bar fl anges and fi xing rings to the
tension bar.
Media
Tension bar fl ange
+
Fixing ring
Tension bar
Tension bar fl ange
+
Fixing ring
18
Create a slack area in the media.
16 inches (41 cm)
S
M
L
24 inches (61 cm)
48 inches (123 cm)
16 inches (41 cm)
S