Oce CS6410, Основное руководство по эксплуатации

Страница: 71 / 98

71
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
Although the Printer is in the print mode, printing does not start with "PREHEATING" displayed on
the operation panel.
Items to be checked Corrective measures
z
Room temperature Raise the room temperature. (Recommended temperature: 20 to 25ºC)
z
Aff ect of air fl ow If the air from the air conditioner or fan is blowing against the paper guide, avoid the
air fl ow (by changing air fl ow direction, orientation of the Printer, or the location of the
Printer).
The transmitted data is not printed.
Items to be checked Corrective measures
z
ONLINE LED (fl ashing?) Check the communication conditions to the host computer.
Media jams occur frequently.
Items to be checked Corrective measures
z
Media type Check whether the media type setting matches the type of media loaded. See “To
print on other media” on page 46.
z
Media loading Install the media properly. See “To load media on the Printer” on page 30.
z
Obstructions in the carriage
path or the media path Remove any obstructions. See “How to clear media jams” on page 73.
z
Suction fan power If the suction fan power is not proper, reduce the power. See Advanced Operation
Guide .
z
Heater temperature setting If the heater temperature is not best set, lower the heater temperature. See Advanced
Operation Guide .
Print quality is poor.
See Advanced Operation Guide.
Blank sheet appears.
Items to be checked Corrective measures
z
Print data Check the current print data to confi rm that you sent the blank sheet's data.
Check your problem / How to clear media jams / When an error message is displayed / Out of ink while printing / The media was skewed.
/ Warning messages / Move the Printer / Replace a waste ink bottle / Install and replace an ink pack / Replace a spittoon case / Replace a
wiper blade