Océ CS6410 Basic Operation Guide
12
Media
Supported media
The Printer supports the solvent inkjet media of the types below. Note that the print condition may change
depending on the environmental conditions and the media production batch. So you are recommended to test
the print with the media beforehand.
For details, contact your service representative.
z
Vinyl
z
Banner
z
Mesh banner
z
Backlit banner (FF)
z
Solvent printing coated paper
Precautions on storing media
At storing media, packed or unpacked, avoid direct sunlight and water stained. To avoid dust put the
media into a box or a bag, and keep it in a cool and dark place.
Avoid a rapid temperature change to prevent a dew condensation.
Do not store media upright. The media stored upright may be deformed to be telescopic due to its
weight, or may deform its edge.
Do not pile up the roll media.
Precautions on disposing of media
Dispose of media or printout in compliance with all local, state, and federal regulations.
Precautions on using media
Do not subject the unpacked media to the temperature and humidity change. Before loading the
media on the Printer, leave the media in the operating environment for three hours or more. Note that
the ambient humidity change may aff ect the media by turning on or off the air conditioner.
The media may be curled in a lower temperature, and wrinkled in a higher temperature. Keep the
temperature around 23°C and the humidity around 50% when you use the media.
Do not use a part of media when the part is scratched, wrinkled, turned, or with obstructions. Never use
the damaged media, as the right and left edges of the media are especially critical to feed media on the
Printer. Besides, do not drop the media and avoid water stained, which may degrade the image quality,
and cause the Printer’s malfunction.
Do not touch the printed image but the margin part. The image quality may be degraded by your
insensible sebum and sweat.
When the media is wound telescopically at loading on the Printer, correct the slippage before using.
Precautions on handling printouts
Do not touch the printed surface of the media before the ink dries, or especially 24 hours after printed.
Handle the printout by securing the margins.
Do not scratch the printout to avoid the color lost or transferred. To avoid the printout’s color
transferred, do not put the printed media on the other printed media with their printed surface facing
each other.
Do not put the printed media on the printout from copier or laser printer. The printouts’ ink or toner
may stick the two printouts.
Note that an ink on the printed surface may come off if the surface is rubbed hard or scratched.
The printed image may bleed or be lost if the water-stained printout is scratched hard or left.
Содержание CS6410
Страница 98: ......
