Oce Arizona 250 GT, Руководство пользователя

Страница: 88 / 178

88 Chapter 5 How to Operate the Arizona 250 GT
How to Create Custom Vacuum Zones
How to Create Custom Vacuum Zones
Introduction
A fabricated aluminum overlay sheet placed on the surface of the printer table is used
to create a vacuum field that is divided into zones. When the printer is installed, a
single zone equal to the maximum media size is available. Vacuum zones can be
configured in the field to meet specific customer requirements for media sizes. This
section describes the procedure to re-configure the vacuum overlay sheet to use
custom zones. These recommended zones shown below are either in Metric or
Imperial dimensions according to operator preference.
The vacuum control handles are used with the custom vacuum zones. When you
create custom zones the three control valves control which zones of the printer table
will have vacuum applied when the table vacuum pump is turned on. The left handle
controls the Left zone, the middle controls the Top zone and the right controls the
Right zone. The vacuum zones are open when the handles are vertical. To close a
zone, turn the control handle a quarter turn clockwise.
Purpose
The vacuum system holds the media in place. The three three suggsted zones
described in this section are arranged to accommodate common media dimensions.
If you create custom zones, they can be turned off or on according to where media
is placed. If you have additional aluminum overlays you can quickly change the
configuration of the vacuum zones by placing another overlay.
When to do
If the suggested custom zones on your printer do not match with media sizes that you
use frequently, it is possible to change the layout of the zones to suit your particular
purpose. This helps to minimize the use of tape and placement of media that will not
be printed on when the media size does not match exactly with the zone size.
Required tool
foam tape - part # 3010106699 - use only to create custom zones (do not use on the
perimeter of the printer table).
Note: Make sure you clean the area with isopropyl alcohol before you apply foam
tape to create a new zone.