Oce Arizona 250 GT, Руководство пользователя

Страница: 152 / 178

152 Chapter 10 Printer Maintenance
Remove Ink From the Table
Remove Ink From the Table
Introduction
How often you need to perform these procedures will vary, depending on printer
usage and work habits.
Remove Ink from Table
Clean ink from the table whenever necessary. Once UV ink is cured, the best method
for removing it from the table is to use a scraper (it is also possible to achieve good
results with a razor blade that is set into a handle/holder). Be careful not to scratch
the aluminium surface of the table when scraping off the cured ink.
Unplug Vacuum Holes
The vacuum holes in the table surface may become plugged with ink and thus reduce
the efficiency of the vacuum. To clear the holes, use an 1.5mm diameter rigid
material (e.g., a paper clip) to ream them out, as required (this is not likely a daily
task, but must be performed as needed).
Required tools
Poly-Wipe Cloth
Nitrile Gloves
Note: When scraping ink off the table be sure to remove all of the dry ink particles.
Use a portable vacuum and then a wet lint-free cloth to ensure no debris is left on
the table that could be picked up by a printhead.
How to Remove Ink
1.
Scrape any cured ink from the surface of the table with a scraper (or a razor blade in
a holder).
2.
Use a vacuum cleaner to remove the scraped particles of ink and any other debris on
the table surface.
3.
Use a lint-free cloth soaked in isopropyl alcohol to ensure that the table surface is
clear of any remaining particles.
How to Unplug Vacuum Holes
1.
Identify any vacuum holes that are plugged with ink.
2.
With an 1.5mm diameter rigid material (e.g., a paper clip), ream out any of the holes
that have been plugged.
3.
Clear any resulting debris with a vacuum cleaner or a wet lint-free cloth.