Oce arizona 1240 GT, Руководство пользователя

Страница: 94 / 212

5.
Accurately center the media using the supplied ruler. Media should be centered within 1mm on
the ruler.
[46] Ruler to Center Media
NOTE
The supplied ruler has both metric (millimeters) and imperial (inches) scales. When a
media roll is centered on the shaft, and the ruler is placed as shown in the photo, the value
on the ruler scale will match the width of the roll. For example, in the photo a 2 meter (or
2000mm) roll is centered on the media shaft.
6.
Lock the supply media shaft core locks by turning the 5mm hex key clock-wise.
7.
Re-check that the media is still centered as locking the core may cause the roll to shift (usually the
shift is from 1 to 2 millimeters to the right).
Next: Load an Empty Core and Install it in the Take-up Position
8.
Place an empty media shaft on a suitable work surface and unlock the media shaft locks with the
5mm hex key.
9.
Slide an empty media core that is at least as long as the supply media width onto the take-up
shaft.
10. Roughly center the core and then insert the shaft into the Take-up (top) position on the RMO unit.
NOTE
Make sure that the core lock and coupler end of the shaft are on the right side of the
printer.
11. Lock the take-up media shaft core locks with the 5mm hex key.
Result
The RMO is now ready to print on the roll media.
Loading the Media - Standard Method
The standard way to load media is quick and efficient and ensures minimum waste of material.
However, for some longer print jobs or when you use media that is more flexible and therefore
harder to achieve good alignment, there is an alternate method that will be described in Section
D. Straight loading of roll media is very important to avoid wrinkles and banding in the print,
Loading the Media - Standard Method
94 Chapter 7 - Roll Media Option
Océ Arizona 1200 Series