NXP Semiconductors PXN2020, Справочное руководство, Страница: 550 / 1376

Enhanced Direct Memory Access Controller (eDMA)
PXN20 Microcontroller Reference Manual, Rev. 1
24-30 Freescale Semiconductor
The eDMA module is partitioned into two major modules: the DMA engine and the transfer control
descriptor local memory. The DMA engine is further partitioned into four submodules, which are detailed
below.
• DMA engine
— Address path: This module implements registered versions of two channel transfer control
descriptors: channel x and channel y, and is responsible for all the master bus address
calculations. All the implemented channels provide the same functionality. This hardware
structure allows the data transfers associated with one channel to be preempted after the
completion of a read/write sequence if a higher priority channel service request is asserted
while the first channel is active. After a channel is activated, it runs until the minor loop is
completed unless preempted by a higher priority channel. This capability provides a
mechanism (optionally enabled by EDMA_CPR
n [ECP]) where a large data move operation
can be preempted to minimize the time another channel is blocked from execution.
— When another channel is activated, the contents of its transfer control descriptor is read from
the local memory and loaded into the registers of the other address path channel{x,y}. After
the inner minor loop completes execution, the address path hardware writes the new values for
the TCD
n .{SADDR, DADDR, CITER} back into the local memory. If the major iteration
count is exhausted, additional processing is performed, including the final address pointer
updates, reloading the TCDn.CITER field, and a possible fetch of the next TCD
n from memory
as part of a scatter-gather operation.
— Data path: This module implements the actual bus master read/write datapath. It includes 32
bytes of register storage (matching the maximum transfer size) and the necessary mux logic to
support any required data alignment. The system read data bus is the primary input, and the
system write data bus is the primary output.
— The address and data path modules directly support the two-stage pipelined system bus. The
address path module represents the 1st stage of the bus pipeline (the address phase), while the
data path module implements the second stage of the pipeline (the data phase).
— Program model/channel arbitration: This module implements the first section of eDMA’s
programming model and also the channel arbitration logic. The programming model registers
are connected to the slave bus (not shown). The eDMA peripheral request inputs and eDMA
interrupt request outputs are also connected to this module (via the control logic).
— Control: This module provides all the control functions for the DMA engine. For data transfers
where the source and destination sizes are equal, the DMA engine performs a series of source
read, destination write operations until the number of bytes specified in the inner minor loop
byte count has been moved.
A minor loop interaction is defined as the number of bytes to transfer ( n bytes) divided by the
transfer size. Transfer size is defined as:
if (SSIZE < DSIZE)
transfer size = destination transfer size (# of bytes)
else
transfer size = source transfer size (# of bytes)