17
EN
6 Basic Operation
Start
WARNING
z
z
Make sure to properly connect the connection plug of the power cord and power plug.
z
z
Always make sure the tool is grounded.
No grounding the tool could cause failure or electric shock at the time of electrical leakage.
If you are not sure about the grounding of the outlet, request an electrical contractor to check if it is grounded.
When an extension cord is used, use a 3-core cord that includes a ground wire.
z
z
Make sure the connection cord is firmly connected.
Other than supplying power, the connection cord is connected to the ground to eliminate static electricity.
The end metal section of the electric screwdriver is connected to the ground via a 1MΩ safety resistor inside the
controller.
Also, when the tool is used for a long time, the rotation part of the electric screwdriver becomes worn and the
ability to remove static electricity decreases. Periodically request our company or your sales agent to perform an
overhaul on the tool.
1
Check that the power is turned OFF, and use the connection cord to connect the electric
screwdriver and controller
Align and insert the connection cord and receptacle notches, and tighten the sleeve.
Cut-out
Sleeve
Connection cord (female pin)
2
Insert the power cord into the controller inlet
3
Insert the power plug into a grounded outlet (100 V AC - 240 V AC) to supply electricity
4
Turn ON ( I ) the power switch
The buzzer sounds, and LED lights up.
The electric screwdriver and controller model, and
program version, are displayed on the LCD.
TV07783-1_DLV10C_en.indb 17
2017/06/27 17:41:36
