NF FRA5014, Инструкция по эксплуатации

Страница: 35 / 107

3.2 Display and Initial Settings at Power-on
FRA5014 3-5
3.2.2 Display at power-on
Follow the setup instructions described above in “
2 PREPARATIONS BEFORE USE
”.
When the power switch is turned on, a beep sounds and then all lamps go on for a few seconds.
During this period, memory self check and other processing are performed. If any errors are found,
the ERROR lamp goes on.
For details, see “
6.1.1 Error at power-on
”
For description of initial settings, see “
3.2.3 Initial Settings
”
If there are no errors in the battery backup, the settings from when the unit was last turned off are
restored.
When the above self check is completed normally, a signal check and self calibration are performed.
During these operations, the CALIBRATION lamp is on. When self calibration ends normally, the
CALIBRATION lamp goes off, and FRA5014 unit is ready to begin taking measurements.
3.2.3 Initial Settings
The FRA5014
’s initial settings are described below.
•
Factory settings
•
Error at power-on when settings in memory have been corrupted
“
3.2.2 Display at power-on
”
•
When the initialization command “*RST” has been entered
The initial settings and their initial values are described below in “ Table 3-1 Settings and
Initial Values
”