© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
215
SLIDEOUTS
If the slideout is stuck in the retracted position,
take the coach to an authorized service center for
diagnosis and repair. Do NOT attempt any of the
following procedures.
IMPORTANT
!
Prior to proceeding with a manual retraction
procedure, make sure the ignition key is in the
o
ff
position and the park brake is set. Then, try
retracting the slideout again, as some controllers
require the ignition to be o
ff
, and others require the
park brake to be set.
IMPORTANT
!
WARNING
!
The manual retraction procedures are for emergency
use only. These procedures bypass all normal safety
features. It is the responsibility of the person(s)
performing the procedure to watch for moving parts
and pinch points in order to avoid injury.
This procedure can be performed on any single
motor electric slideout.
IMPORTANT
!
Option 1
This option requires the motor and gear box to be
operational. This procedure bypasses the slide controller,
switch, and the wiring. If battery power is unavailable, or
if the motor/gear box is inoperable, move to a di
ff
erent
option.
1. Disconnect the red and
black wires connected to
the motor.
2. Using the the wires
attached to the motor,
connect to a 12 volt cordless
battery to retract the
slideout. If the wire polarity
is reversed, the slideout will
extend instead of retract.
If the slideout motor has a brake installed, you must
also hook one brake wire to the battery with the red
slideout motor wire and one with the black slideout
motor wire.
IMPORTANT
!
This can also be done at the slideout controller’s wiring
harness by removing the motor’s red and black harness
plug from controller and jumping a 12 VDC power source
at the Molex plug.
3. Disconnect the wire(s) from the cordless battery pack.
Option 2
If the slideout is stuck in the extended position and option
1 is unavailable or fails:
COACHES WITH MECHANICAL LOCK
ARMS
1. Slide the motor back over onto the square shaft, and
reinstall the four mounting bolts.
2. The motor and brake assembly must be installed
(or another way devised) to hold the slideout in the
retracted position prior to traveling.
3. Take the coach to an authorized service center for
diagnosis and repair.
COACHES WITH MANUAL LOCK ARMS
1. Remove the four mounting bolts, and move over the
slideout motor until it disengages from the square
shaft.
2. Manually push the room in or out.
3. Lock the room with manual lock arms (if equipped).
4. Take the coach to an authorized service center for
diagnosis and repair.
Make sure you do not damage portions of the
shaft that will slide through the motor, trantorque,
bearing, and cog wheels.
IMPORTANT
!
Option 3
If the slideout is stuck in the extended position and option
1 and/or 2 is unavailable or fails, try the following steps
to manually retract the slideout by removing the brake
and turning the shaft. Only a few tools are necessary to
complete this procedure; however, it requires the gear
box to be operational.
This procedure can be performed on coaches with a
brake on the slideout motor.
IMPORTANT
!
Содержание VENTANA 2022
Страница 1: ...SM 2022...