Introduction
11
ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R
•
Packet fragmentation and reassembly
•
Auto or long preamble
•
Roaming among wireless access points on the same subnet
Autosensing Ethernet Connections with Auto Uplink
The wireless access point can connect to a standard Ethernet network. The LAN interface is
autosensing and capable of full-duplex or half-duplex operation.
The wireless access point incorporates Auto Uplink technology. The Ethernet port
automatically senses whether the Ethernet cable plugged into the port should have a
“normal” connection such as to a computer or an “uplink” connection such as to a switch or
hub. That port then configures itself correctly. This feature also eliminates any concerns
about crossover cables, as Auto Uplink accommodates either type of cable to make the right
connection.
Hardware Description
This section describes the top and rear hardware functions of the wireless access point.
•
Top Panel
•
Rear Panel
•
Bottom Panel with Product Label
Top Panel
The LEDs of the wireless access point are described in the following figure and table:
1
2
3
4
5
Figure 1. Top panel with LEDs
