NetApp NearStore R100, Руководство по аппаратуре и обслуживанию

Страница: 147 / 164

Chapter 9: Troubleshooting LCD Messages 137
Cannot initialize
labels When the system tries to create
a new file system, it cannot
initialize the disk labels. Yes Usually, you do not need to create
and initialize a file system; do so
only after consulting Network
Appliance Technical Support.
Cannot read labels When the chassis tries to
initialize a new file system, it
has a problem reading the disk
labels it wrote to the disks.
This problem can be because the
system failed to read the disk
size, or the written disk labels
were invalid
Yes Usually, you do not need to create
and initialize a file system; do so
only after consulting Network
Appliance Technical Support.
Disk label processing
failed The chassis detects that the disk
is not in the correct drive bay. Yes Make sure that the disk is in the
correct bay.
Dirty shutdown in
degraded mode The file system is inconsistent
because you did not shut down
the system cleanly when it was
in degraded mode. Yes Contact Network Appliance
Technical Support for instructions
about repairing the file system.
Halted: firmware too
old The disk firmware is an old
version. Yes Update the disk firmware by
entering the following command:
disk_fw_update
No disk controllers The system cannot detect any
disk controllers. Yes Turn off power to the chassis and
verify that all adapters are
properly seated in the appropriate
expansion slots.
No disks The system cannot detect any
disks. Yes Verify that all disks are properly
seated in the drive bays.
Boot error message Explanation Fatal? Corrective action