Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
34
X = 1 - function enabled,
X = 0 - function disabled.
Setting the camera mode
The tracker has two modes of shooting: periodic and by event.
In the "periodic" mode, the photo-taking is performed after a preset period of time. The time
between saving photos in the "periodic" mode is set by the command
«CAMPERIOD X»
X is the time in seconds.
In the "by event" mode, the photo-taking is performed when the logic level on the analog
input changes. To properly operate in this mode, it is necessary to adjust the voltage levels for
discrete states on the analog input (see clause 7.1 Analog inputs).
Parameters of the "by event" mode are set by the command
«CAMEVENT X, Y, Z».
X is the number of the analog input, which initiates the photo-taking when the logic 1 appears
thereon.
Y is the number of photos in a series. If Y = 0, the photo-taking will stop only when a logical 0
appears on the selected analog input.
Z is the time between photo-takings, in seconds.
It is also necessary to set the range for the logical "0" and the logical "1" for the selected
input.
ATTENTION!
After the configuration is completed, the tracker needs to be restarted.
Transferring photos to the server
Saving a photo to a microSD memory card takes up to 7 seconds. Sending one photo to the
server takes 15-120 seconds, depending on the network condition. Pictures are saved in 640x480
resolution and take about 45-50kb each on a microSD memory card.
Photos transferring to the server is activated by the command
«CAMUPLOAD X»
.
X = 1 - enable photos transferring to the server,
X = 0
– disable photos transferring to the server.
«CAMUPLOADSIZE»
displays the number of shots in the queue for transmission to the
server.
«CAMUPLOADNUL»
cancels the upload to the server of all photos on the memory card
that are in the transmission queue.
7.5.3 CAN-LOG connection
To connect the CAN-LOG, do the following:
