Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
49
second, instead of any analogue input data.
Use «
ACCELALARM
» command to install analogue input number. Use «
PROTOCOL
»
command to start IN_A data block transmission (analogue inputs).
10.3 Alarm system
The tracker is equipped with three alarm types:
⎯
When the vehicle gets beyond the arming point and exceeds the pre-set distance. If there
are valid coordinates, the point where the arming command was received should be
considered as the arming point. In the absence of such coordinates, the first valid
coordinates received after accepting the arming command, will be considered as the arming
point.
⎯
When the vehicle exceeds the pre-set speed limit. This alarm is not used for controlling
vehicle driving speed, but is used to record the fact of movement. Alarm parameters are set
by the «
GPSGUARD
», «
GPSALARMTEXT
» commands when moving.
⎯
When there is voltage within the pre-set range in the analogue input. For this function it is
necessary to set SMS sending condition according to the event in the input by the
«
INTRUESMS
» command and the message text by the «
INTRUESMSTEXT
» command.
When an alarming event occurs, the tracker can send up to four SMS messages to different
phone numbers and activate the discrete output with the «
INTRUEOUT
» command.
For working with the list of alarm phone numbers, use the «
EVENTLISTADD
»,
«
EVENTLISTSHOW
», «
EVENTLISTCLEAR
» commands. Phone numbers might be duplicated in
the list of authorized numbers but SMS messages, based on the events, are sent only to these
numbers.
Arming and disarming are performed with the
«
GUARD ON
», «
GUARD OFF
», «
ALARM
OFF
» commands. It is possible to perform arming based on the event in one of the analog inputs.
For this, it is necessary to select this input with the «
INGUARDMODE
» command and set a range
for logical «1» and logical “0” therefor. The tracker will pass to the guard mode if the voltage values
in this input are set within the logical “1” range.
Deactivation of such an arming mode is performed by the «
INGUARDMODECLEAR
»
command.