Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
36
- set the required RS-232 port to the Autotracker mode;
- enable the data block "FUEL" transmission with the
«PROTOCOL»
command.
The
«LLSAT»
command shows the current fuel level read from the Autotracker sensors.
7.5.5 Tachograph connection
The tachograph connection is made to the RS-485 bus or to any of the RS-232 ports. Then,
you should select the type of tachograph and the tracker port in the graphical interface of the
ADMConfigurator program (version no lower than 2.1) or with the command
«TACHOENABLED X,
Y»
.
X - Type of the connected tachograph.
X = 0 - Tachograph VDO
X = 1 - Tachograph SHTRICH-M
X = 255 - function disabled
Y - Terminal Port
Y = 0 - RS232_0
Y = 1 - RS232_1
Y = 2 - RS485
If necessary, readings transmission from the tachograph odometer should be enabled,
instead of the readings from the built-in odometer of the tracker via the command
«TACHOTRODOMETR X»
.
X = 0 - readings from the tracker odometer are transmitted
X = 1 - readings from the tachograph odometer are transmitted
The ODM command shows the current value of the active odometer in meters.
It is necessary to include the transfer of driver’s card numbers in the fields intended for
transferring the voltage level on the analog inputs AIN4 and AIN5 using the command
«TACHOTRCARDNUMBER X»
.
X = 0 - transmission disabled
X = 1 - transmission enabled
The command
«TACHOGETCARDNUMBER X»
shows the number of the inserted map, X -
the number of the tachograph slot.
To start uploading the DDD file from the tachograph to the monitoring system via GPRS, you
should send the
«TACHOGETDDD X»
command, where X is the card slot number.