Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
16
6.3 Data transmission settings
Navigation data and the data collected from different sensors, which are sent from the tracker
to the server, are divided into blocks. Depending on the functions used the set of transmitted data
is defined by the
«PROTOCOL»
command
.
Data block compliance with the command parameters values are provided below in the Table
1. If it is necessary to transmit data from several blocks,
«PROTOCOL»
command parameter is
calculated based on addition. It is possible to use any variants.
For saving traffic it is recommended to activate only necessary data blocks.
For example:
basic data(0)+analogue inputs(8)+fuel level sensors(32)=PROTOCOL 40
basic data(0)+analogue inputs(8)+outputs, events as per inputs(4)=PROTOCOL 12
basic data(0)+pulse inputs(16)+odometer values(128)=PROTOCOL 144
Table 1. Basic parameters values for PROTOCOL command
Data block name
Parameter value
Basic data
NAVIGATION DATA
0
Outputs, events per inputs
OUTS
4
Analogue inputs
IN_A
8
Pulse inputs
IN_D
16
Fuel level sensors
FUEL
32
Can
CAN
64
Odometer value
ODOMETR
128
6.4 Setting coordinates freezing during a parking
The margin of error might cause a slight coordinates dispersion during a long-term parking of
the vehicle. To prevent this effect the coordinates freezing function might be used in the beginning
of the parking. This mode is activated automatically when there is no vibration (installed by default),
or when the discrete level is changed in the analogue input (setting is needed).
The acceleration meter measures the current level of vibration (accelerations sum in three
axis). If the vibration level below the threshold continues more than a minute and half, the tracker
records the last valid coordinates received from GLONASS/GPS module and transmits them to the
server in all further packets. When the vibration level threshold increases more than by 5 seconds,
the coordinates freezing mode is deactivated, and the valid coordinates received from
GLONASS/GPS module are transmitted. The vibration level threshold is installed by the
«
MAXACC
» command. This mode activation is performed by the INSTATIC 15,1 command.