Neomatica ADM700 3G, Руководство по эксплуатации

Страница: 37 / 80

Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
37
7.6 Working with a headset
The tracker allows for giving outgoing calls to the pre-entered numbers. To give an outgoing
call, it is necessary to press the headset button. The numbers for outgoing calls are added with the
«EVENTLISTADD»
command. The outgoing call is given to the number, which is the first in the list.
If connection fails, the tracker passes to the next number in the list. In case when no number is
available, calling will be stopped. The list of numbers is reviewed by the
«EVENTLISTSHOW»
command, and cleared by the
«EVENTLISTCLEAR»
command. The
«MAKECALLTIME»
command sets the time during which the tracker will be trying to call to each number. The
«RINGS»
command sets the number of calls attempts, after which the autoreply to the incoming
call will be initiated. The call loudness is adjusted by the
«RINGVOLUME»
command, the
interlocutor's voice loudness is set in the headset, and the microphone sensitivity
– by the
« VOLUME»
command.
7.7 1-Wire bus
Up to 8 temperature sensors can be connected to the 1-Wire bus. To do this, you should do
the following:
- connect the temperature sensors to the 1-Wire bus in accordance with the diagram in
Figure 15;
- configure the bus with the
«OWCONFIG»
command (after the OWCONFIG command is
entered, each device gets a sequence number);
- enable the transmission of the "Analog Input" data block by the
«PROTOCOL»
command;
- enable the transfer of the temperature sensor readings by the command
«OWTHERMOENABLED 1».
The readings from temperature sensors are transmitted in the fields intended for transferring
the voltage level at the analog inputs. The sensor numbers assigned when configuring the 1-Wire
bus with the
«OWCONFIG»
command correspond to the numbers of the analog inputs. Disabling
the temperature sensor readings transmission is done with the command
«OWTHERMOENABLED 0».
The command
«OWCONFIGINFO»
shows all the connected devices and assigned sequence
numbers.
To request the readings from any of the sensors connected to the 1-Wire bus, enter the
«OWTHERMO X»
command, where X is the sensor serial number (0 ... 7).