Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
32
Table 3. Eventual operation modes of the ports RS-232 0 and RS-232 1
Y parameter
Operation mode
0
Fuel level sensors
1
Camera, OV528 protocol
3
CAN-LOG
4
Fuel level sensors Autotracker
An example of setting with the command:
SET232 0,1 - for the port RS-232 0 the mode 1 is set.
SET232 1,3 - for the port RS-232 1, the mode 3 is set.
The
«SET232»
command without parameters requests the established modes of both ports,
in the format:
Port number = port mode, Port number = port mode.
For example: 0 = 1,1 = 3, which means:
Port RS-232 0 = Camera, Port RS-232 1 = CAN-LOG.
7.5.1 Fuel level sensors connection
To connect fuel level sensors, it is necessary to do the following:
- disable automatic data output in the sensor settings;
- set the data transmission speed to 19200 bauds in the sensor settings;
- connect the fuel level sensors in accordance with the diagram in Figure 13;
- set the required RS-232 port to the operating mode with the fuel level sensor.
Data transmission is performed in the data block "Analog inputs". To do this, you must enable
the corresponding data block with the
«PROTOCOL»
command. Transmission of the «FUEL»
data block is not required.
The command
«LLSTOIN X, Y»
establishes the correspondence between the sensor
address and the analog input number, instead of which the fuel level will be transmitted.
X is the number of the analog input
Y - sensor address
