NEC POWERMATE ES 5200 - SERVICE, Руководство по обслуживанию

Страница: 43 / 306

2-6 System Configuration
NEC 32X CD-ROM Drive Jumper Settings
The factory settings for the jumpers on the NEC 32X CD-ROM drive are shown
in the following table. The drive is set as the master device on the secondary
channel. Specifications for the CD-ROM drive are included in Section 10.
NEC 32X CD-ROM Drive Jumper Settings
Jumper Jumper Pin Settings
Cable Select (CS) Not used.
Slave Present (SL) Disabled, pin 2 open (factory default).
Enabled, pin 2 jumpered.
Master Select (MA) Enabled, pin 3 jumpered (factory default).
Disabled, pin 3 open.
Lite-ON 32X CD-ROM Drive Jumper Settings
The factory settings for the jumpers on the Lite-ON 32X CD-ROM drive are
shown in the following table. The drive is set as the master device on the
secondary channel. Specifications for the CD-ROM drive are included in
Section 10.
Lite-ON 32X CD-ROM Drive Jumper Settings
Jumper Jumper Pin Settings
Cable Select (CS) Not used.
Slave Present (SL) Disabled, unjumpered (factory default).
Enabled, jumpered.
Master Select (MA) Enabled, jumpered (factory default).
Disabled, unjumpered.
Zip Drive Jumper Settings
The factory settings for the jumpers on the Zip drive are shown in the following
table. The settings description applies when looking at the back of the drive,
with the IDE connector to the left of the jumper block. The drive is set as the
slave device on the primary channel. Specifications for the Zip drive are
included in Section 10.
Zip Drive Jumper Settings
Jumper Jumper Pin Settings
Drive 0 Select (Master Drive Select) Right two pin sets jumpered.
Drive 1 Select (Slave Drive Select) Right-most pin set jumpered.
Cable Select Mode All three pin sets jumpered.