NEC POWERMATE ES 5200 - SERVICE, Руководство по обслуживанию

Страница: 107 / 306

3-24 Disassembly and Reassembly
5.
Connect the drive cables.
6. Insert the drive the rest of the way into the drive bay, making sure that the
screw holes on the right side of the drive bracket align with the screw holes
in the right side of the diskette drive.
7.
Secure the drive with two screws.
8.
Replace the front panel (see “Replacing the Front Panel — Desktop”).
9.
Replace the system unit cover (see “Removing the Small Desktop or
Desktop Cover”).
10. Run the Setup program to set the new configuration (see “CMOS Setup
Utility” in Section 2).
Removing a Diskette Drive — Minitower
Use the following procedure to remove a diskette drive from a 3 1/2-inch
accessible drive bay in a minitower system.
1.
Remove the left side cover (see “Removing the Minitower Side Covers”).
2.
Remove the front panel (see “Removing the Front Panel — Minitower”).
3.
If necessary, remove the top cover for better access to the drive connectors
(see “Removing the Minitower Top Cover”).
4. Disconnect and label the diskette drive cables.
5. Remove the two screws on the left side of the drive (see the following
figure).
Removing Diskette Drive Screws — Minitower
6.
Slide the drive out of the drive bay.
7.
If you are installing a new drive, see “Installing a Diskette Drive —
Minitower.”