NEC POWERMATE ES 5200 - SERVICE, Руководство по обслуживанию

Страница: 114 / 306

Disassembly and Reassembly 3-31
Installing a 3 1/2-Inch Hard Drive — Small Desktop
To install a 3 1/2-inch internal hard drive, proceed as follows.
1.
Follow the preinstallation instructions that come with your device, such as
setting jumpers.
2.
Remove the system unit cover (see “Removing the Small Desktop or
Desktop Cover”).
3.
If a currently installed hard drive is being replaced, see “Removing a 3 1/2-
Inch Hard Drive — Small Desktop.”
4.
Align the screws on the new hard drive with the holes in the bracket.
5.
Secure the hard drive to the bracket with the four screws that came with the
drive or the screws from the old drive (see the figure in “Removing a 3 1/2-
Inch Hard Drive — Small Desktop”).
6.
With the cable connectors toward the rear of the system, position the bracket
and hard drive on the chassis braces and align the screw holes.
7.
Insert and tighten the two screws to secure the bracket to the chassis braces.
8.
Connect the device cables.
9.
Replace the system unit cover (see “Replacing the Small Desktop or
Desktop Cover”).
10.
Run the Setup program to set the new configuration (see “CMOS Setup
Utility” in Section 2).
Removing a 3 1/2-Inch Hard Drive — Desktop
To remove a 3 1/2-inch device from the 3 1/2-inch internal device bay, proceed
as follows.
1.
Follow the preinstallation instructions that come with your device, such as
setting jumpers.
2.
Remove the system unit cover (see “Removing the Small Desktop or
Desktop Cover”).
3.
Label the IDE device signal and power cables connected to the drive and
then disconnect them.
4. Remove the two screws securing the internal hard drive (see the figure on
the following page).
5.
Lift the internal hard drive out of the bracket over the power supply.
6.
If you are installing a new hard drive, see “Installing a 3 1/2-Inch Hard
Drive — Desktop.”