NEC N8100-1573F, Руководство пользователя

Страница: 228 / 394

8-6 Troubleshooting
Disk LED
The hard disk drive bay of 2.5-inch model server can contain four hard disk drives. Each hot-plug
hard disk drive has a DISK LED on its front panel.
The Disk LED indicates the drive status as follows.
„
Blinking green
Indicates that the hard disk drive is accessed.
„
Lighting amber
Indicates that the installed hard disk drive is defected.
NOTE:
While hard disk drives are in the RAID configuration (RAID1),
a single failed hard disk drive does not affect the operation of the server.
However, it is recommended to replace the failed hard disk drive and
auto-rebuild (reconfigure) the hard disk drives as soon as possible. (You
can hot-swap such a failed hard disk drive.)
„
Alternate blinking amber and green
Indicates that the hard disk drive is being rebuilt (this status is not a failure). If the
defected hard disk drive is replaced with a new one in the RAID configuration, the data is
automatically rebuilt (auto rebuild function).
The LED goes off when the rebuild is terminated normally. The LED goes on amber if the
rebuild fails.
IMPORTANT:
Powering off the server aborts rebuilding. In such a
case, restart the server, hot-swap the failed hard disk drive, and restart
rebuilding. Observe the following notes to use the auto-rebuild feature.
„
Do not power off the server. (If the server is powered off before
rebuilding hard disk drives, the auto-rebuild feature will not start.)
„
When you removed a hard disk drive, wait at least 90 seconds
before installing the hard disk drive back again.
„
Do not replace another hard disk drive while rebuilding is in
progress.
Disk LED