NEC N8100-1573F, Руководство пользователя

Страница: 275 / 394

Upgrading Your Server 9-19
Notes
Observe the following notes on installing/removing a PCI board:
„
Do not touch the terminals of the PCI board and PCI riser card and the leads of electronic
components with your bare hand. Fingerprints and dust left on them cause the server to
malfunction due to a connection failure or damage to the leads.
„
A riser card is designed for installing only low-profile PCI board. Before installing a PCI
board, make sure of the card specification.
„
Set "Disabled" for the option ROM of a LAN device not to be booted by using the BIOS
SETUP utility.
„
If an additional LAN device is installed, it is hard to push the catch of the connector with
your finger that is connected to the LAN port. Disconnect the connector pushing the catch
with a standard screwdriver. At this time, be very careful for the screwdriver not to
damage the LAN port or other ports.
„
If a bootable LAN card is additionally installed, the boot priority may be changed. After
the additional installation, run the BIOS SETUP utility, select [Boot] and set the new boot
priority.
„
See the table below for available boards and slots.
Slot (Bus A)
Product Name
PCIe #1 *1
PCI slot capability x8 lane
Slot size LowProfile
PCI board type x8 socket
N Code
Available board size *2 MD2
Remarks
N8103-109
*3
RAID Controller (128MB, RAID 0/1/5/6)
√
∗1
N8103-116 *3 RAID Controller (128MB, RAID 0/1)
√
∗1
N8103-117
*3
RAID Controller (128MB, RAID 0/1/5/6)
√
∗1
N8103-104A SAS Controller
√
∗1
N8104-126 1000BASE-T Adapter
√
∗1
N8104-122 1000BASE-T Adapter (2ch)
√
∗1
N8104-125 1000BASE-T Adapter (4ch)
√
∗1
√
: Available, –: Unavailable
*1 Optional riser card N8116-20 (PCI Express) must be installed to use the PCI slot.
*2 Depth of PCI board available for slot:
Board of low-profile type: Depth 167.6 mm max., width 64.4 mm max.
*3 To install a 2.5-inch SAS hard disk drive, you need to install RAID Controller (N8103-
109, N8103-116/117).