NEC N8100-1573F, Руководство пользователя

Страница: 124 / 394

4-48 Configuring Your Server
CONFIGURING MOTHER BOARD JUMPERS
With the pre-installed SETUP utility, you can set desired passwords to protect the data stored in the
server against access from unauthorized users. When you forget the passwords, however, you may
want clear them. The following describes how to clear these passwords. You can also use the
following procedure to clear the CMOS data in the server.
IMPORTANT:
Clearing the CMOS data resumes the factory-set
configuration data.
To clear passwords or the CMOS data, use the jumper switch on the mother board of the server. See
Chapter 2 for the jumper switch location.
IMPORTANT: Do not change any other switch settings. Any change
may cause the server to fail or malfunction.
The following describe the clearing procedure.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-11 for details.
„
Do not disassemble, repair, or alter the server.
„
Do not remove the lithium battery.
„
Disconnect power cord before working with the server.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-11 for details.
„
Never attempt to lift the server only by yourself.
„
Make sure to complete board installation.
„
Do not install the server on a rack with leaving covers removed.
„
Do not pinch your finger with mechanical components.
„
Note high temperature.
„
Do not pull out a device from the rack if the rack is unstable.
„
Do not leave more than one device being pulled out from the rack.