NEC Express5800/A1080a, Руководство пользователя, Страница: 545 / 696

Hardware
545
system1 target
This target is regarding the system.
system1/nic1 target
This target is for the network settings of the system.
Below is the property of the target.
ipaddress :
Set the network IP address for the system as static
It is valid when committed=1 is set.
subnetmask :
Set the network subnet mask for the system as static
It is valid when committed=1 is set.
usedhcp
Specify whether if DHCP for the network IP address of the system is used or not.
DHCP is enabled when usedhcp=1 and this setting is valid when committed=1 is set.
defaultgatewayaddress
Set the IP address for the default gateway.
It is valid when committed=1 is set.
committed
Validate the property settings such as ipaddress, subnetmask,usedhcp and
defaultgatewayaddres when committed=1 is set.
macaddress
Display the mac address of the management board.
・
IMPORTANT:
• Don’t use set command which changes the MAC address
because it might cause malfunction of the management firmware.
• It is not possible to set IP address, subnet mask, default gateway,
DHCP at the same time. Set and commit(committed
=1) each value one by one.
• Set the address of IP Addr/IP Mask/Gateway Addr within the
network of the same segment.
• Set an arbitrary unused address for Gateway Addr even if
Gateway does not exist. It is not possible to disable the Gateway
Addr.
• When setting a network, conflict check of IP address is executed
for 10-20 seconds. During the check it is not possible to set the
other network newly. Wait for a moment until the check is done.
• While setting the network or operating the system, the conflict
check of IP address is executed periodically. If any confliction is
detected, the IP address and its IP mask will be treated as
invalid,=0.0.0.0. After removing the factor of the confliction, set
the network again.