National Flooring Equipment ROGUE, Руководство по эксплуатации и обслуживанию

Страница: 29 / 84

407170_ROGUE_RevA
CHANGING THE BLADE
MACHINE OPERATION
29 29
Blade fully seated against notch.
To avoid personal injury:
● Always wear safety gloves when handling blades.
Blades are sharp and could be very hot.
● Remove blade holder from tooling holder and
place on level surface before replacing blade.
WARNING
1. Remove blade holder from machine.
2. Loosen the hex head cap screws keeping hand safely
away from sharp edge of the blade. It is not necessary to
remove the screws.
3. Remove old blade.
4. Place new blade into the blade holder and slide back
until fully seated against the notch.
IMPORTANT:
● Do not insert blade all the way back to the screws.
Incorrect installation will cause insufficient clamping
leading to premature blade wear and damage.
If the blade is wider than the blade holder, center the
blade in the holder. If the blade is smaller than the blade
holder, the blade should be mounted in the center of the
holder during the first pass. After the first pass is made,
the blade can be offset in the holder to allow the wheels
to keep even contact with the floor and provide easy ac -
cess to the wall.
5. Tighten the screws.
6. Reinstall blade holder.
Removing the blade.
Offset blade
Notch