National Flooring Equipment ROGUE, Руководство по эксплуатации и обслуживанию

Страница: 19 / 84

407170_ROGUE_RevA
OPERATING CONTROLS
19 19
6
7 8
9
10
2
1
3
4
5
11
12 13
[6] System Indicator
Indicates system status:
● Amber indicates startup mode.
● Pulsating green indicates machine is ready to operate.
● Flashing red indicates a system fault. Reference “TROU-
BLESHOOTING” section for fault codes.
[7] Drive Speed Control
Sets the maximum drive speed of the machine.
[8] Orbital Motor Speed Control
Adjusts the oscillation rate of the tooling holder.
[9] Blade Angle Control
Adjusts the angle of the blade.
[10] Hour Meter
Displays operating hours.
[11] Left/Right-Hand Preference Switch
Determines functionality of the control handles based on
operator preference.
[12] [13] Left and Right Control Handles
The control handles are used to control the travel direction,
turning and drive speed of the machine. Reference the “MA-
CHINE OPERATION” section for detailed information.
[1] Emergency Stop Switch (E-Stop)
Push to immediately shut down the machine in case of
emergency.
● Reset Procedure
If engaged, must be reset before the machine can be
restarted. To reset, twist red button clockwise to release.
[2] Lanyard Kill Switch
Operator presence control (OPC) that immediately shuts
down the machine if the operator gets separated from the
machine’s controls. The switch is held open by a key at-
tached to a lanyard that is tethered to the operator. If the
operator moves too far from the switch, the lanyard pulls the
key from the switch shutting down the machine.
● Reset Procedure
If engaged, must be reset before the machine can be
restarted. To reset, reinsert the key into the kill switch.
[3] Power Indicator
The power indicator illuminates when the machine is con-
nected to power.
[4] ON Button
Push the green “ON” button to turn on the controls. The sys-
tem indicator will pulsate green.
[5] OFF Button
Push the red “OFF” button to disable the controls.