National Flooring Equipment ROGUE, Руководство по эксплуатации и обслуживанию

Страница: 34 / 84

407170_ROGUE_RevA
TRANSPORTING THE MACHINE
34 34
1. Remove weights.
2. Make sure transport wheels are installed.
3. Engage the wheels so the machine is in drive mode.
4. Plug machine into power source.
5. Turn on the machine and slowly back up the ramp.
6.
Turn off machine and unplug from power source.
7. Remove transport wheels and install empty blade holder
for stability.
8. Tie down the machine using proper tie-down locations.
1. Make sure weights are removed.
2. Remove blade holder and install transport wheels.
3. Make sure the wheels are engaged so the machine is in
drive mode.
4. Plug machine into power source.
5. Turn on the machine and slowly drive down the ramp.
NOTE:
● Use caution when driving down ramp as the machine
will overrun the drive motor speed. Pulsate the con-
trol handle knob in reverse to “brake” the machine.
6. Turn off machine and unplug from power source.
7. Attach weights making sure to properly secure to ma-
chine.
IMPORTANT:
● Make sure the load capacity of the ramp is greater than
the weight of the operator and machine.
● Machine weight is shown in “MACHINE SPECIFICA-
TIONS” section and on serial number label.
● Make sure the ramp is not damaged and properly se-
cured to the truck/trailer bed.
● Do not use the machine on a ramp that exceeds a 36%
grade (20° incline).
● Remove all weights from machine before loading and
unloading. Make sure weights are properly secured dur-
ing transport.
● Use the transport wheels when loading and unloading.
● Drive the machine under power when moving the ma-
chine up or down the ramp. Using the freewheel mode
could result in loss of control causing serious injury.
● Operator should never be positioned below machine on
the ramp. Always back the machine up the ramp and
drive the machine down the ramp.
● Drive the machine slowly. Do not make directional
changes when machine is on the ramp.
● Electrical cords create a tripping hazard. Be careful not
to trip over the extension cord while driving the machine.
● Before tying down machine, make sure wheels are en-
gaged and install empty blade holder for stability.
● Use appropriate tie-down hardware to secure machine.
● Always inspect the tie-down hardware before each use.
Do not use if worn or damaged.
● Use only proper tie-down locations. Do not attach the
tie-down hardware to handle, weights, cutting head or
tooling holder. Weights and handle could detach causing
injury. The machine could be damaged.
● Load disengagement can cause severe injury or prop-
erty damage. Always make sure tie-down hardware is
properly connected.
● Make sure all attachments are properly secured during
transport.
● Follow your company’s safety guidelines to avoid injury.
To avoid personal injury:
● Instructions for safe transporting using a vehicle
equipped with a ramp are described below. Read
these instructions carefully before transporting.
Personnel in proximity of the machine must wear
adequate safety equipment.
WARNING
VEHICLE WITH RAMP
If a liftgate is not available, a ramp may be used to load and
unload the machine.
■
Ramp Loading
■
Ramp Unloading
Tie-down locations